Filter
Top Products
VPN
Client to Gateway
92 Cisco RV320/RV325 Administration Guide
9
- IKE with Certificate—Use a certificate to authenticate a remote IKE
peer.
• Enable—Check to enable this VPN.
Configuring Easy VPN
Enter the following information:
• Name—Name to describe the tunnel. For a single user, you can enter the
username or location. This description is for your reference and does not
have to match the name used at the other end of the tunnel.
• Minimum Password Complexity—When enabled, the password minimum
requirements are:
- Eight characters in length.
- Not match the the username.
- Not match the current password.
- Contain characters from at least 3 of the following categories:
uppercase letters, lowercase letters, numbers, special characters
available on the standard keyboard (' ' " \ are not supported).
• Password—Easy VPN password.
• Password Strength Meter—When Minimum Password Complexity is
enabled, the Password Strength Meter indicates the password strength,
based on the complexity rules. The scale ranges from red (unacceptable) to
yellow (acceptable) to green (strong).
• Interface—WAN port to use for this tunnel.
• Enable—Check this box to enable the VPN tunnel, or uncheck it to disable
the tunnel. By default, the tunnel is enabled.
• Tunnel Mode—Split Tunneling allows Internet destined traffic to be sent
unencrypted directly to the Internet. Full Tunneling sends all traffic to the
head-end device where it is then routed to destination resources
(eliminating the corporate network from the path for Web access).
• IP Address—IP address assigned to the VPN interface.
• Subnet Mask—Subnetwork mask.