Filter
Top Products
Introduction
Accessing the Command Line Interface
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 22
1
Accessing the Command Line Interface
The Command Line Interface (CLI) can be accessed from a terminal or computer
by performing one of the following tasks:
• Running a terminal application, such as HyperTerminal, on a computer that is
directly connected to the Switch’s console port,
—or—
• Running a telnet session from a command prompt on a computer with a
network connection to the Switch.
If access is via a telnet connection, ensure that the following conditions are met
before using CLI commands:
• The Switch has a defined IP address.
• Corresponding management access is granted.
• The workstation used to access the Switch is connected to the Switch.
Using HyperTerminal over the Console Interface
NOTE When using HyperTerminal with Microsoft® Windows® 2000, ensure that
Windows® 2000 Service Pack 2 or later is installed on your computer. The arrow
keys will not function properly using HyperTerminal’s VT100 emulation in
Windows® 2000 prior to Service Pack 2. For information on Windows® 2000
service packs, go to www.microsoft.com.
The Switch’s RS-232 serial console port provides a direct connection to a
computer’s serial port using a standard DB-9 null-modem or crossover cable.
Once the computer and Switch are connected, run a terminal application such as
HyperTerminal to access the Command Line Interface.
To access the Command Line Interface using the HyperTerminal application,
perform the following steps:
STEP 1 Click the Start button.
STEP 2 Select All Programs > Accessories > Communications > HyperTerminal.