Filter
Top Products
Ethernet Configuration Commands
port storm-control broadcast enable
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 175
12
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of jumbo frames on the device.
Console# show port jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration (Ethernet) mode
command enables Broadcast storm control. Use the no form of this command to
disable Broadcast storm control.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode
command, to set the maximum allowable Broadcast rate.