Filter
Top Products
24
Cisco uBR10-LCP2-MC16C/MC16E/MC16S Cable Interface Card for the Cisco uBR10012 Router
OL-2872-02
Replacing the Line Card in the Cisco uBR10-LCP2 Adapter Card
Step 2 Remove the cable interface line card from the chassis. See the “Removing a Cisco uBR10-LCP2-MC16x
Cable Interface Line Card” section on page 17.
Step 3 Place the cable interface line card on an antistatic surface, omponent side facing up (see Figure 12).
Step 4 Loosen and remove the two sets of retaining nuts and washers on the L-brackets on the cable interface
line card and set the nuts and washer aside.
Step 5 Loosen the two captive screws on the cable interface line card. See Figure 12.
Step 6 To disengage the Cisco cable interface line card from the Cisco uBR10-LCP2 adapter card,
simultaneously grip the ejector levers and the ejector tabs with your thumbs and index fingers.
Step 7 Press the ejector levers back against the ejector tab. The card snaps loose from the adapter card.
Step 8 Pull the cable interface line card straight out of the adapter card with the handle. See Figure 14.
Step 9 Place the removed cable interface line card aside on an antistatic surface.
Figure 12 Removing the Nuts and Washers
US0
US1
US2
US3
US4
US5
DS
ENABLED
+42 dBmV
uBR-MC16C
62448
Captive screw
Captive screw