Filter
Top Products
— 19 —
4.5 Hexadecimal Dump Printing
This function is to print all received data in hexadecimal numbers. If problems such as
missing data, data duplication, etc. should occur, this function allows checking whether
or not the printer is receiving data correctly.
Set paper to the printer and keep the printer cover open. With the FEED button pressed
and held, turn the printer power on and then close the printer cover. The printer prints
“HEX dump print mode” followed by the received data printed in hexadecimal numbers
and some characters.
4.4 Self-printing
Insert paper into the printer. With the FEED button pressed and held, turn the printer
power on, keep the FEED button held for about 1 second, and then release the FEED
button. The printer starts self-printing. The printer prints model name, version, DIP
switch setting, memory switch setting, and built-in fonts.
Memory
switch
setting
Serial communication
condition (Only serial
interface model)
DIP switch setting
(Only serial interface
model)
Firmware version
Interface
Buffer size
CAUTION!
■ The printer prints “.” if there is no characters corresponding to data.
■ During hexadecimal dump, functions except some command will be disabled.
■ If print data DOES NOT cover a line, press the FEED button to print the line.
When you press the FEED button three times consecutively, or you turn the printer power
off, or the printer receives a reset signal from the interface, the hexadecimal dump printing
is terminated.
Print example
HEX DUMP PRINT MODE
1B 21 00 1B 20 04 41 42 43 44 .!.. .ABCD
45 46 47 48 49 4A 4B 4C 4D 4E EFGHIJKLMN
4F 50 0D 0A 31 32 33 0D 0A OP..123..