Filter
Top Products
Removal and Replacement Procedures
Maintenance and Service Guide 5–33
2. Remove the three M2.5 × 5.5 screws
1
securing the hard
drive and hard drive bracket to the base enclosure
(Figure 5-20).
3. Remove the hard drive bracket
2
from the base enclosure.
4. Slide the hard drive toward the front of the base enclosure
3
to disconnect it from the system board.
5. Remove the hard drive from the base enclosure
4
.
Figure 5–20: Removing the Hard Drive
Reverse the above procedure to install the hard drive.
238850-003.book Page 33 Friday, December 21, 2001 2:53 PM