Filter
Top Products
5. Remove the display cable and backlight cable from the inverter board
(Section 3.25).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
When servicing the computer, ensure that cables are placed in their proper
location to avoid pinching during the reassembly process. Improper cable
placement can cause severe damage to the unit.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
6. Remove the CTFT (10.4 inch) panel from the display enclosure. Refer to
"Removing the CTFT (10.4 inch) Display Panel" in this section.
7. Remove the display cable. Refer to "Removing the CTFT (10.4 inch)
Display Cable" in this section.
8. Remove the display shield. Refer to "Removing and Replacing the CTFT
(10.4 inch) Display Shield" in this section.
9. Disconnect the display ground cable [1] from the LIF clip above the
serial port connector on the system unit module (Figure 3-168).
10. Lift the display ground cable out of the display enclosure (Figure 3-169).