Compaq 410C 486 DX2/50 MHZ 250 MB 4 MB 9.5 Personal Computer User Manual


 
2. Remove the keyboard assembly (Section 3.7).
3. Using a Torx T-8 or flat-bladed screwdriver, remove the screw from the
front right-hand corner of the integrated mechanical trackball assembly
(Figure 3-37).
4. Disconnect the integrated mechanical trackball assembly from the system
board by pulling forward on the integrated mechanical trackball
assembly until it stops.
5. Tilt up the front of the integrated mechanical trackball assembly and
lift it up to clear the connectors and the system board (Figure 3-38).