Filter
Top Products
--------------------------------------------------
The card is not From MS-DOS: For memory
formatted. cards, run MEMCARD to
format the card. For
hard drive cards and
flash mass storage
cards, run ATACARD,
then run FORMAT.
From Windows: Select
Computer Setup from the
Compaq Control Center,
then select MEMCARD or
ATACARD from the PC Card
option.
-------------------------------------------------
The card is not Contact Compaq Reseller
supported. Support for a list of PC
Cards tested successfully
in Compaq PC Card
platforms.
===========================================================================
Table 5-25. Solving Printer Problems *
===========================================================================
Problem Probable Cause Solution(s)
===========================================================================
Printer does not The device drivers Install the correct printer
print. for the application drivers for the application
are not installed. to the CONFIG.SYS file.
---------------------------------------------------
Printer that is set Connect the printer to the
up for a network is network.
not connected to the
network.
---------------------------------------------------
Printer cable is too Replace the cable.
long, unshielded, or
defective.
---------------------------------------------------------------------------
Printer is off-line. Paper tray is empty. Fill the paper tray and
select Online.
---------------------------------------------------------------------------
Printer prints Correct printer Install the correct printer
garbled information. drivers are not driver.
installed.
---------------------------------------------------
Cable is not Connect printer cable
connected properly to properly to the computer.
computer.
---------------------------------------------------
Printer cable is too Replace the cable.
long, unshielded, or
defective.
---------------------------------------------------------------------------
* If you experience problems printing, run a printer self-test to
determine if it is a printer-specific problem. Refer to the
documentation provided with the printer and the application software.
===========================================================================