Filter
Top Products
2. Remove the two Phillips PM2.5×4.0 screws (1) and the ten Phillips PM2.5×9.0 screws (2) that secure
the top cover to the computer.
3.
Turn the computer right-side up, with the front toward you.
4. Disconnect the caps lock LED board cable (1) from the system board.
5. Release the ZIF connector to which the TouchPad cable is connected and disconnect the cable (2)
from on the system board.
6. Lift the rear edge of the top cover (1) and swing it (2) up and forward until it rests at an angle.
Component replacement procedures 57