Filter
Top Products
Removing the Monitor Base
Before you can mount the monitor onto a swing arm or other
mounting fixture, you must remove the monitor from the base.
CAUTION:
Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and signal cables are both
disconnected.
To remove the monitor from the base, complete the following
steps:
1. Lay the front bezel down on a soft area to prevent it from
getting scratched, defaced, or broken.
2. Remove the cover plate 1 from the monitor base by placing
your fingers in the opening on the bottom of the base and
pulling upward, then pulling out to remove the cover.
3. Remove the back panel 1 from the monitor by pushing the
bottom tabs upward and pulling out to remove the back
panel.
4. Disconnect and remove the signal and power cables from the
back of the monitor.
5. Remove the four screws 2 as shown in the following
illustration.
TFT8030 User’s Guide 11