Filter
Top Products
Using the System Control Manager 8-31
Table 8–4 SCM Troubleshooting (Continued)
Symptom Possible Cause Suggested Solution
SCM will not answer
when modem is called.
On power-up, SCM defers
initializing the modem for
30 seconds to allow the
modem to complete its
internal diagnostics and
initializations.
Wait 30 seconds after
powering up the system
and SCM before
attempting to dial in.
After the system is
powered up, the COM1
port seems to hang and
then starts working
after a few seconds.
This delay is normal.
Wait a few seconds for
the COM1 port to start
working.
New escape sequence
is forgotten.
At the SRM prompt,
enter the following:
P00>> SCM show status
Theescapesequenceis
shown in the output.
Or, reset the system to
factory defaults.