Filter
Top Products
3. The power cord set must have a minimum current capacity of 2.5A and a
nominal voltage rating of 125 or 250 volts AC, as required by each
country's power system.
4. The appliance coupler must meet the mechanical configuration of an EN
60 320/IEC 320 Standard Sheet C7 connector, for mating with appliance
inlet on the AC Adapter.
Country-Specific Requirements
2-Conductor Power Cord Set Requirements - By Country
===========================================================================
Country Accredited Agency Applicable Note Numbers
===========================================================================
Australia EANSW 1
Austria OVE 1
Belgium CEBC 1
Canada CSA 2
Denmark DEMKO 1
Finland FIMKO 1
France UTE 1
Germany VDE 1
Italy IMQ 1
Japan JIS 3
The Netherlands KEMA 1
Norway NEMKO 1
Sweden SEMKO 1
Switzerland SEV 1
United Kingdom BSI 1
United States UL 2
---------------------------------------------------------------------------
NOTES 1: Flexible cord must be <HAR> Type HO3VV-F, 2-conductor, 0.75 mm2
conductor size. Power cord set fittings (appliance coupler and
wall plug) must bear the certification mark of the agency
responsible for evaluation in the country where it will be used.
2: Flexible cord must be Type SPT-2 or equivalent, No. 18 AWG,
2-conductor. Wall plug must be a two-pole type with a NEMA 1-15P
(15A, 125V) configuration.
===========================================================================