Filter
Top Products
A-4 Troubleshooting
Writer: M. Silvetti Saved by: Marianne Silvetti Saved date: 11/12/99 10:20 AM
Part Number: 383706-001 File name: CAppA.doc
Continued
Lamp shuts off
1. If all five LEDs flash amber, the
projector has overheated and will
automatically shut down. Wait
five to ten minutes until the LED
buttons stop flashing and the
Standby Button turns amber
before restarting the projector
again.
2. A minor power surge may cause
the lamp to shut off. Wait a few
minutes, then turn it back on.
Lamp burns out or makes a
popping sound
When the lamp reaches its end of life,
it will burn out and may make a loud
popping sound. If this happens, the
projector will not turn back on until
the lamp module has been replaced.
Contact your local Compaq
authorized dealer, seller, or reseller
to purchase a replacement lamp
module. To replace the lamp, follow
the procedures in the "Replacing the
Projector Lamp Module" section.