Filter
Top Products
How to Use the Board
COM-2(PC)F8
Compatible Mode Installation Procedure 2
1. Turn on the power to the PC without inserting the COM-2(PC)F
in an expansion slot.
2. After Windows Me/98 starts, select [Control Panel] from [My
Computer] and start the [Add New Hardware].
3. Click [Next >] in response to [To begin installing your new
hardware, click Next] in the Add New Hardware Wizard.
4. Select [No] in response to [Do you want Windows to search for
your new hardware ?].
5. Select the [Ports (COM & LPT)] folder from the [Hardware
types:] screen.
6. Select [Communication Port] from [Models:] and click on [Have
Disk...] in the screen.
7. When the [Install From Disk] screen appears, place the floppy
disk in the drive, enter the drive name in [Copy manufacturer's
file from:], then click [OK].
8. The next screen displays the board type. Select [CONTEC Co.,
Ltd. - COM-2(PC)F, V, H Compatible] from [Models:].
9. Next, the resource items and settings are displayed. Take a
note of the displayed I/O address and interrupt level.
10.End the operation as instructed. This completes the installation
of one port. When using both ports in Compatible mode,
repeat the procedure from step 2. If the interrupt level used by
a COM-2(PC)F port is already used on the PC, change the
interrupt level to an available level.
11. Turn off the power, then set the operation mode (I/O address)
and interrupt level on the COM-2(PC)F to the values set in steps
9 and 10 above. Set the COM-2(PC)F switch and jumpers as
described in Hardware Setup.