Filter
Top Products
Getting Started
2-11
2.5 Powering-on the Subsystem
When you connect the Disk Array to the Host computer, you should press
the ON/OFF Power Supply Switch. It will turn the Disk Array on and the Self-
Test will be started automatically.
1. Plug in all the power cords or power connectors located at the rear of
the subsystem.
2. Turn on the power.
3. The “Power” LED on the front panel will turn green. After a few moments
the LCD should display the following message:
{Model Name}
xxx.xxx.xxx.xxx
Note:
The subsystem is equipped with redundant PFC (power factor
correction), Full Range power supplies. The subsystem will auto-
matically selector voltage.
!