Filter
Top Products
Getting Started
2-15
2.8 Connecting to a PC or Terminal
The subsystem is equipped with a serial monitor port located at the rear of
the system unit. This serves as an alternative display when accessing the
setup utility.
Description
Data Carrier Detect (DCD)
Receive Data (RD)
Transmit Data (TD)
Data Teminal Ready (DTR)
Signal Ground (SG)
Data Set Ready (DSR)
Ready To Send (RTS)
Clear To Send (CTS)
Ring Indicator (RI)
Pin
1
2
3
4
5
6
7
8
9
Note:
Refer to Chapter 3 for instructions on accessing the setup utility
through a PC or terminal, as well as instructions on setting the baud
rate, stop bit, data bit and parity of your monitor or terminal. The
default setting of the monitor port is 115200 baud rate, non-parity, 8
data bit and no flow control.