Filter
Top Products
12
Web Configuration
Corinex AV200 Powerline Ethernet Adapter
3.4 Change Configuration Page
3.4.1 Overview
The configuration page allows you to change some basic parameters on the adapter.
Any parameter changed here will be stored in the adapter‘s permanent memory, and
loaded and configured automatically after the next system boot. Any changes will
take effect immediately after bootup, with the exception of Network Configuration
settings (these require a reset of the adapter).
Notes:
• A different IP must be set for each adapter within a single network. An adapter’s
IP does not need to be in the same range as the PCs communicating with the
adapters. But to access the configuration page, a PC must have the same address
range as the adapter (10.10.X.X and netmask 255.255.0.0 in the default state).
• The adapter’s netmask can also be changed, for example to a type C
(255.255.255.0) if necessary. This is a more advanced option, which you may
ignore if you’re not familiar with it.