Filter
Top Products
19
Web Configuration
Corinex AV200 Powerline Ethernet Adapter
3.4.8 Security Configuration
The web application allows you to change the configuration password by typing a
new one in the specified fields (You must confirm your password by re-typing it in
the second field). If both fields are left empty, the configuration password will be
disabled (the message ‘No password installed’ will be shown in the security configu
-
ration form). Consequently, the web configuration authentication will be disabled
too. The authentication can be enabled again by setting a password.
If you want to restore the adapter‘s default settings, you can invoke a factory reset.
In order to do this, you have to enter the password „betera“ in the appropriate
field and click OK. The adapter will reboot with the following configuration:
- IP address = 10.10.1.69
- Configuration interface password = paterna
- Factory reset password = betera
- Device type is Automatic EP/AP
- Network Identifier is blank
- No encryption and no VLAN settings
3.4.9 Hardware Reset
Clicking on this button will reset (or reboot) your adapter. The configuration will
remain the same, and any changes made in the Network Configuration section will
be applied. This means that if you’ve changed the IP address, the adapter will reboot
with that new address.