Filter
Top Products
24
• Print one of the Printer Setup Forms (Configuration Menu or Program1/Program2 Menu) or the Offset
Tuning Form. See “ Printing the Printer Setup Forms” later in this manual
• Insert a filled-in Printer Setup Form to set the corresponding Setup values.
P
P
r
r
i
i
n
n
t
t
i
i
n
n
g
g
t
t
h
h
e
e
T
T
e
e
s
s
t
t
P
P
a
a
g
g
e
e
The Self Test page is useful to test, if the printer has been correctly installed, and allows to see the current
parameter settings.
1. With the printer in the Setup Mode, insert a single sheet in A4 or Letter format.
2. The printer loads the sheet and stops.
3. Press the
ON LINE key again.
The printer prints the Self-Test page. Check that the printout is correct. The following printout example shows
the Printer Setup default values.
Once the self-test is finished, the printer remains in Setup Mode.
SEL F TEST
SP-40 : Code Version Vx.x xxxxxxxx CharGen:xxxxxxxx ver. x.xx
CONFIGURATION SETUP
PROGRAM progr.1 AUTOFEED SIGNAL disabled
ERROR BUZZER 1 beep SLCT-IN SIGNAL disabled
JOB BUZZER no beep IGNORE PE enabled
SECURITY MODE enabled BUFFER CONTROL XON/XOFF
PASSBOOK TYPE vertical ROBUST XON enabled
GET EDGE QUOTE 1/2” WORD LENGTH 8 bit
INTERFACE TYPE automatic BAUD RATE 9600 bps