Filter
Top Products
Integrated Professional Automation Computer Crestron IPAC
Attach the IPAC to the Mounting Plate
Use the two included 04-40 x ¼” screws to attach the IPAC to the mounting plate as
shown in the following diagram.
CAUTION: Excess wire that is pinched between the IPAC and the electrical box could
short out. Make sure that all excess wire is completely inside the electrical box and not
pinched between the box and the IPAC or the mounting plate.
SCREWS (2) 04-40 x ¼"
(2007156)
Apply Custom Labels
Pre-printed labels for the seven buttons on the IPAC can be applied to the label strip.
Remove the Label Holder
As shown in the following diagram, slide the label holder up and remove it from the
IPAC.
PUSH LABEL HOLDER UP
AND PULL AWAY FROM THE
IPAC
6 • Integrated Professional Automation Computer: IPAC Installation Guide – DOC. 6696A