Filter
Top Products
Crestron IPAC Integrated Professional Automation Computer
Affix Labels to the Label Holder
As shown in the following diagram, attach labels to the label holder. The included labels
are shown in the appendix on page 11.
Install the Label Holder
As shown in the following diagram, attach the label holder by placing the holder tabs in
the slots and sliding them downward into position.
PLACE LABEL HOLDER TABS
IN SLOTS.
SLIDE TABS DOWN TO
SECURE IT.
Attach the Faceplate to the IPAC
Use the included 04-40, 7/16” screws to attach the faceplate to the IPAC as shown in the
following diagram.
AFTER ATTACHING FACEPLATE,
VERIFY FACEPLATE PLACEMENT BY PUSHING
ALL BUTTONS TO ENSURE SMOOTH OPERATION.
IF ANY BUTTONS STICK, LOOSEN SCREWS,
REPOSITION FACEPLATE AND RETIGHTEN SCREWS.
SCREWS (4) 04-40 x
7
16
"
(2022900 or 2013409)
Installation Guide – DOC. 6696A Integrated Professional Automation Computer: IPAC • 7