Filter
Top Products
PRELIMINARY
CY14B104K, CY14B104M
Document #: 001-07103 Rev. *K Page 20 of 31
AutoStore/Power Up RECALL
Parameters Description
20 ns 25 ns 45 ns
Unit
Min Max Min Max Min Max
t
HRECALL
[23]
Power Up RECALL Duration 20 20 20 ms
t
STORE
[24]
STORE Cycle Duration 8 8 8 ms
t
DELAY
[25]
Time Allowed to Complete SRAM Cycle 20 25 25 ns
V
SWITCH
Low Voltage Trigger Level 2.65 2.65 2.65 V
t
VCCRISE
VCC Rise Time 150 150 150 μs
V
HDIS
[14]
HSB Output Driver Disable Voltage 1.9 1.9 1.9 V
t
LZHSB
HSB To Output Active Time 5 5 5 μs
t
HHHD
HSB High Active Time 500 500 500 ns
Switching Waveforms
Figure 12. AutoStore or Power Up RECALL
[26]
V
SWITCH
V
HDIS
V
VCCRISE
t
STORE
t
STORE
t
HHHD
t
HHHD
t
DELAY
t
DELAY
t
LZHSB
t
LZHSB
t
HRECALL
t
HRECALL
HSB OUT
Autostore
POWER-
UP
RECALL
Read & Write
Inhibited
(
RWI)
POWER-UP
RECALL
Read & Write
BROWN
OUT
Autostore
POWER-UP
RECALL
Read & Write
POWER
DOWN
Autostore
Note
24
Note
24
Note
27
Notes
23. t
HRECALL
starts from the time V
CC
rises above V
SWITCH.
24. If an SRAM write has not taken place since the last nonvolatile cycle, no AutoStore or Hardware STORE takes place.
25. On a Hardware STORE, Software STORE / RECALL, AutoStore Enable / Disable and AutoStore initiation, SRAM operation continues to be enabled for time t
DELAY
.
26. Read and Write cycles are ignored during STORE, RECALL, and while VCC is below V
SWITCH.
27. HSB pin is driven HIGH to VCC only by internal 100kOhm resistor, HSB driver is disabled.
[+] Feedback