Filter
Top Products
CY8C22113, CY8C22213
Document Number: 38-12009 Rev. *F Page 22 of 36
AC Electrical Characteristics
AC Chip-Level Specifications
The following table lists guaranteed maximum and minimum specifications for the voltage and temperature ranges: 4.75V to 5.25V
and -40°C ≤ T
A
≤ 85°C, or 3.0V to 3.6V and -40°C ≤ T
A
≤ 85°C, respectively. Typical parameters apply to 5V and 3.3V at 25°C and
are for design guidance only or unless otherwise specified.
Table 23. AC Chip-Level Specifications
Symbol Description Min Typ Max Units Notes
F
IMO
Internal Main Oscillator Frequency 23.4 24 24.6
a
MHz Trimmed. Using factory trim
values.
F
CPU1
CPU Frequency (5V Nominal) 0.93 24 24.6
a,b
a. 4.75V < Vdd < 5.25V.
b. Accuracy derived from Internal Main Oscillator with appropriate trim for Vdd range.
MHz
F
CPU2
CPU Frequency (3.3V Nominal) 0.93 12 12.3
b,c
c. 3.0V < Vdd < 3.6V. See Application Note AN2012 “Adjusting PSoC Microcontroller Trims for Dual Voltage-Range Operation” for information on trimming for opera-
tion at 3.3V.
MHz
F
48M
Digital PSoC Block Frequency 0 48 49.2
a,b,d
d. Refer the individual user module data sheets for information on maximum frequencies for user modules.
MHz Refer to the AC Digital
Block Specifications.
F
24M
Digital PSoC Block Frequency 0 24 24.6
b,e,d
e. 3.0V < 5.25V.
MHz
F
32K1
Internal Low Speed Oscillator Frequency 15 32 64 kHz
F
32K2
External Crystal Oscillator – 32.768 – kHz Accuracy is capacitor and
crystal dependent. 50%
duty cycle.
F
PLL
PLL Frequency – 23.986 – MHz Is a multiple (x732) of
crystal frequency.
Jitter24M2 24 MHz Period Jitter (PLL) – – 600 ps
T
PLLSLEW
PLL Lock Time 0.5 – 10 ms
T
PLLSLEWSLOW
PLL Lock Time for Low Gain Setting 0.5 – 50 ms
T
OS
External Crystal Oscillator Startup to 1% – 1700 2620 ms
T
OSACC
External Crystal Oscillator Startup to 100 ppm – 2800 3800
f
f. The crystal oscillator frequency is within 100 ppm of its final value by the end of the T
osacc
period. Correct operation assumes a properly loaded 1 uW maximum
drive level 32.768 kHz crystal. 3.0V
≤ Vdd ≤ 5.5V, -40
o
C ≤ T
A
≤ 85
o
C.
ms
Jitter32k 32 kHz Period Jitter – 100 ns
T
XRST
External Reset Pulse Width 10 – – μs
DC24M 24 MHz Duty Cycle 40 50 60 %
Step24M 24 MHz Trim Step Size – 50 – kHz
Fout48M 48 MHz Output Frequency 46.8 48.0 49.2
a,c
MHz Trimmed. Using factory trim
values.
Jitter24M1 24 MHz Period Jitter (IMO) – 600 ps
F
MAX
Maximum frequency of signal on row input or
row output.
– – 12.3 MHz
T
RAMP
Supply Ramp Time 0 – – μs
[+] Feedback