Filter
Top Products
98 I-Class
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
UPQ!PG!GPSN!GBVMU
The printer could
not find the TOF
mark within the
maximum label
length setting or it
found a TOF in an
unexpected place.
;
Note: When the
printer is set for
reflective media,
this fault is given
for an out of stock
condition.
If media is moving:
1) Press the FEED Key. It
may be necessary to re-
calibrate the printer; see
Section 5.0.
2) The Media Sensor may be
out of position. Readjust it;
see Section 3.2.
3) The media may not be
properly loaded. Reload
media, also ensure that the
Media Guide is positioned
properly; see Section 3.1.
4) The Leveling Cam ma y be
improperly adjusted; see
Section 5.1.1.
5) The label may be longer
than the default value for
maximum length. Check
the Media Settings /
Maximum Label Length;
see Section 4.1.2.
6) The Media Sensor may be
obstructed. Check and
carefully remove any
obstruction (labels, paper
dust, adhesive, etc).
If media is not moving:
The printhead assembly may
not be latched; close and lock
it.