Filter
Top Products
book.book Page 50 Monday, June 25, 2012 11:55 AM
Removing the Power/Battery Status-Light Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 8. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 10. For additional safety best
practices information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Prerequisites
1 Follow the instructions from step 1 to step 7 in "Removing the Base Cover" on
page 11.
2 Remove the battery. See "Removing the Battery" on page 21.
3 Remove the speakers. See "Removing the Speakers" on page 47.
Procedure
1 Peel the mylar from the power/battery-status-light board.
2 Lift the connector latch and, using the pull-tab, disconnect the
power/battery status-light cable from the system board.
3 Note the location of the tape and peel it from the power/battery status-light cable.
4 Remove the screw that secures the power/battery status-light board to the
palm-rest assembly.
50 | Removing the Power/Battery Status-Light Board