Dell 1545 Laptop User Manual


  Open as PDF
of 51
 
Back to Contents Page
USB Extend Cable
Dell™Inspiron™1545ServiceManual
Removing the USB Extend Cable
Replacing the USB Extend Cable
Removing the USB Extend Cable
1. Follow the instructions in Before Working Inside Your Computer.
2. Remove the palm rest (see Removing the Palm Rest).
3. Remove the two screws that secure the USB connector.
4. Remove the USB extend cable from the routing guide.
5. Disconnect the USB extend cable from the system board connector.
6. Lift the cable out of the computer base.
Replacing the USB Extend Cable
1. Place USB connector along with the USB extend cable in the routing guide on the computer base.
2. Replace the two screws that secure the USB connector.
3. Connect the cable to the system board connector.
4. Replace the palm rest (see Replacing the Palm Rest).
Back to Contents Page
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the
computer.
NOTICE: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™isnot
covered by your warranty.
1
cable connector
2
cable routing
3
screws (2)
4
USB connector
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.
 previous