Filter
Top Products
Back to Contents Page
Inverter Board
Dell™Vostro™320ServiceManual
Removing the Inverter Board
NOTE: You may need to install Adobe®Flash®Player from Adobe.com to view the following illustrations.
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the front panel.
3. Remove the internal panel.
4. Remove the I/O cover.
5. Remove the hinged stand.
6. Remove the optical drive.
7. Remove the back cover.
8. Remove the tape from the inverter-board shield.
9. Remove the screws that secure the inverter-board shield to the system-board shield.
10. Remove the inverter-board shield from the computer.
11. Disconnect the inverter-board cable from the inverter.
12. Disconnect the two display cables from the inverter board.
13. Remove the screws that secure the inverter to the system-board shield.
14. Remove the inverter board from the computer.
Replacing the Inverter Board
To replace the inverter board, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.