Filter
Top Products
Removing and Installing Parts 83
7
Connect the data cable to the back of the drive and to the floppy drive connector on the
system board (see page 56).
NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
8
Reattach the front panel (see page 72).
9
Replace the computer cover (see page 89).
NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in
to the computer.
10
Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
11
Enter system setup (see page 96) and update the appropriate
Diskette Drive
option.
12
Verify that your computer works correctly by running the Dell Diagnostics (see page 40).
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
1
Follow the procedures in "Before You Begin" on page 47.
2
Remove the computer cover (see page 54).
3
Release and remove the front panel (see page 70).
power cable
data cable