Filter
Top Products
7. Replace the front bezel (see Replacing the Front Bezel).
8. Replace the computer cover (see Replacing the Computer Cover).
9. Connect your computer and devices to electrical outlets, and then turn them on.
10. Configure the drives in system setup (see System Setup Options).
Replacing the Optical Drive
1. Follow the procedures in Before You Begin.
2. Gently slide the optical drive into the optical-drive bay through the front of the computer.
3. Align the screw holes in the optical drive with the screw holes in the drive panel.
4. Replace the two screws that secure the optical drive to the drive panel.
5. Connect the power cable and the data cable to the optical drive.
6. If disconnected, connect the data cable to the system board connector (see System Board Components).
7. Replace the front bezel (see Replacing the Front Bezel).
8. Replace the computer cover (see Replacing the Computer Cover).
9. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the optical drive for instructions on installing any software required for optical drive operation.
10. Check the System Setup for drive configuration changes (see Entering System Setup).
Back to Contents Page
1
power cable
2
data cable
3
optical drive
4
screws (2)
5
drive panel