Filter
Top Products
PowerConnect 6224/6224F/6224P/6248/6248P Release Notes
System Firmware Version 3.2.0.6 Page 13
¾ Trap Configuration
In previous versions of the software, configuration of the flags for controlling traps was scattered about in a
number of places.
snmp-server enable traps is now a common command for configuring all trap flags. The legacy
commands are preserved for backward compatibility. Also note that the keyword “trap” has changed to the
plural “traps”.
¾ SNTP Server Priority
The server priority is now available from the show sntp configuration command. Previously it was only
configurable.
¾ GARP Leave Timer
The valid range for the GARP leave timer has been changed to 20-600 centiseconds.
¾ IP Multicast Static Route Configuration
The command for configuring a static IPv4 multicast route has changed to ip mroute. The ip multicast
staticroute command is deprecated.
¾ Support for Long User Names
The show users, show users accounts, and show users login-history commands have changed. The long
parameter has been added to these commands to support long usernames.
¾ Flow Control
Flow Control is enabled by default.
Note: When you upgrade a switch to this release, flow control is automatically enabled. If your previous
configuration had flow control disabled, you must disable flow control after the upgrade to match the
previous configuration.
¾ VLAN Limit Increases
MAC based VLAN limit was increased from 128 to 256.
Subnet based VLAN limit was increased from 64 to 128.