Filter
Top Products
26 System Firmware Version 3.2.0.6
Summary User Impact Workaround
Bridge multicast
address is shown as
MAC Address format
in show running-
config buffer when it
is configured in IP
format.
If a user configures the bridge multicast
address as an IP address format in VLAN
interface mode, it is displayed in the show
running-config command in MAC address
format.
None.
Connected spanning
tree root port role not
changed to auto-
portfast after
disabling MSTP on
Trunk.
A port that is a root port will not become auto
edge port if the bridge that the root port is
connected to goes away.
This means that the port would flush the
Forwarding Database entries every time that
there is a topology change. This could be
avoided if the link goes down and comes
back up.
Three commands are
not available at
interface range
Ethernet level, but
are available at
interface.
The following commands are not available to
use in interface range Ethernet level: isdp,
lacpa, and protocol.
Each interface must be configured
individually.
There is no command
to add protocol vlan
in interface range
mode.
The user cannot use interface ranges to
configure a protocol VLAN.
Each protocol VLAN must be configured
individually.
Invalid error port
number displayed on
log message when
VLAN is changed to
forbidden mode from
access mode.
When port is changed to forbidden mode
from access mode, the log message below
is generated that reports the wrong port
number.
<187> OCT 12 08:39:03 10.131.6.173-1
DOT1Q[104741168]: dot1q_api.c(525) 2475
%% Port(88)
This log message is correct when a port
from the base unit is selected.
None.
Gratuitous ARP
packets are not being
generated when
management VLAN is
changed with static IP
configuration.
If the user changes the management VLAN,
then management connections must be re-
established on the new VLAN. Neighbors
will resolve the switch’s management IP
address on the new VLAN.
None.
Using interface range
mode not able to
configure protected
ports.
Cannot use interface range mode to
configure protected switchports.
The user must configure each protected port
individually.
TFTP fails to display
specific error
message when
incorrect filename
was given while
downloading the
code.
If a user attempts to tftp a non-existent file to
the image of the switch, nothing will be
downloaded and there will not be an error
message generated.
None.
Web needs to provide
an option to configure
sFlow sampler / poller
values on range of
interfaces.
User will not be able to select range of
interfaces through web for the Sampler and
Poll Configuration web pages. However,
configuration is not affected as user can
individually select the interfaces and
configure.
User has to select each interface individually
to configure in the Sampler Configuration
and Poll Configuration web pages.