Dell 740-MT Personal Computer User Manual


  Open as PDF
of 217
 
Badcommandorfilename— Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct
pathname.
Bad error-correctioncode(ECC)ondiskread— See Drive Problems.
Controllerhasfailed— See Drive Problems.
Dataerror— See Drive Problems.
Decreasingavailablememory—
See Lockups and Software Problems.
Diskettedrive0seekfailure— See Drive Problems.
Diskettereadfailure—
See Drive Problems.
Diskettesubsystemresetfailed— Run the Dell Diagnostics (see Dell Diagnostics).
Diskettewriteprotected— Slide the write-protect notch on the floppy disk to the open position.
Drivenotready— Put a floppy disk in the drive.
GateA20failure—
See Lockups and Software Problems.
Hard-diskconfigurationerror—
Hard-diskcontrollerfailure—
Hard-diskdrivefailure—
Hard-diskdrivefailure—
See Drive Problems.
Insertbootablemedia— Insert a bootable floppy disk or CD.
Invalid configuration information -pleaserunSETUPprogram— Enter system setup and correct the computer configuration information
(see Entering System Setup).
Keyboardfailure— See Keyboard Problems.
Memory address line failure at address, read value expecting value — See Lockups and Software Problems.
Memoryallocationerror—
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.
 previous next