Filter
Top Products
5. Remove the Media Card Reader and bracket from its packaging.
6. Ensure that the Media Card Reader is installed before the FlexBay USB cable is connected.
7. Make sure the FlexBay USB cable is connected to the back of the Media Card Reader.
8. Insert the Media Card Reader by sliding and holding the drive latch release downward. Then, slide the drive in to seat it in the computer.
9. Route the USB cable through the cable routing clip.
10. Replace the computer cover.
CD/DVD Drive
Removing a CD/DVD Drive
1. Follow the procedures in "Before you Begin."
2. Remove the computer cover.
3. Remove the drive panel.
4. Disconnect the power and data cables from the back of the drive.
NOTE: Connect the USB cable on the back of the Media Card Reader to the front panel USB connector on the system board.
1
Media Card Reader
2
FlexBay cables
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.