Filter
Top Products
Replacing the stand assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the stand assembly on the middle cover.
2 Connect the touch screen cable to the middle cover.
3 Route the cable through the routing clip.
4 Adhere the tape over the touch screen cable.
5 Turn the stand assembly over and slide the tabs on the stand assembly
into the slots on the middle cover.
6 Replace the screws that secure the stand assembly to the middle cover.
7 Route all the cables through their routing guides.
For more information, see Display panel with stand assembly.
8 Replace the screws that secure the cables to the middle cover.
9 Align the antenna modules with the alignment posts and adhere them to
the middle cover.
10 Adhere the tapes that secure the cables to the middle cover.
11 Slide the display cable into the display-cable connector slot and connect
the display cable to the middle cover.
12 Replace the screws that secure the cables to the middle cover.
13 Connect the power-button cable and control-buttons board cable to the
control-buttons board cable.
14 Connect the converter-board cable to the converter board.
Post-requisites
1 Replace the microphones.
2 Replace the camera.
3 Replace the back cover.
81