Filter
Top Products
DHCPv6 Commands 855
FILE LOCATION: C:\My Documents\ActiveProjects\2CSPC7000-SWUM400 Dell Zeiss CLI
Guide\working\DHCPv6.fm
DELL CONFIDENTIAL – PRELIMINARY 3/10/11 - FOR PROOF ONLY
User Guidelines
This command shows the DHCP status. Information displayed depends on
the mode.
The command output provides the following information for an interface
configured in client mode. Not all fields will be shown for an inactive client.
Term Description
Mode Displays whether the specified interface is in Client, Relay, or
Server mode.
State State of the DHCPv6 Client on this interface. The valid values
are:
INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW,
REBIND, RELEASE.
S er ve r D UI D D H CP v6 U n iq ue I de nt i fi er of th e D HC Pv 6 S er ve r o n t h is
interface.
T1 Time The T1 (in seconds) time as indicated by the DHCPv6 Server.
T1 value indicates the time interval after which the address is
requested for renewal.
T2 Time The T2 (in seconds) time as indicated by the DHCPv6 Server.
T2 value indicates the time interval after which the Client
sends Rebind message to the Server in case there are no replies
to the Renew messages.
Interface IAID An identifier for an identity association chosen by this Client.
Leased Address The IPv6 address leased by the DHCPv6 Server for this
interface.
Preferred Lifetime The preferred life time (in seconds) of the IPv6 Address leased
by the DHCPv6 Server.
Valid Lifetime The valid life time (in seconds) of the IPv6 Address leased by
the DHCPv6 Server.
Renew Time The time remaining (in seconds) to send a DHCPv6 Renew
request to DHCPv6 Server for the leased address.
Expiry Time The time (in seconds) when the DHCPv6 leased address
expires.
2CSPC4.XModular-SWUM200.book Page 855 Thursday, March 10, 2011 11:18 AM