Filter
Top Products
208 Adding and Replacing Parts
a
Enter system setup, select
Integrated NIC
, and then change the
setting to
On
.
b
Connect the network cable to the network connector on the back
panel of the computer.
Removing a PCI Express Graphics Card from an SLI Configuration
This section covers only those systems where the graphics cards are set up to
operate in SLI mode. For removal of any other types of PCI or PCI Express
cards, see "Removing an Expansion Card" on page 202.
NOTE: To upgrade to or downgrade from an SLI configuration, you will need
additional parts that can be ordered from Dell. See "Contacting Dell" on page 287.
1
Follow the procedures in "Before You Begin" on page 139.
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55
lbs) and can be difficult to maneuver. Seek assistance before attempting to lift,
move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid
injury; avoid bending over while lifting. See your
Product Information Guide
for
other important safety information.
CAUTION: The computer stand should be installed at all times to ensure
maximum system stability. Failure to install the stand could result in the computer
tipping over, potentially resulting in bodily injury or damage to the computer.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 141).