Filter
Top Products
Dell
™
Latitude™ XT2 XFR Service Manual
Page 45 of 94
Version A00-01
15. Remove the palm rest from the XT2 XFR.
4.9.2 Installing the Palm Rest
1. Insert the cable clamp over the LCD cables and secure with the cable clamp to base screws.
CAUTION: Make sure the cable clamp is set properly over the cable gasket and the
cable gasket is secure before proceeding. Failure to perform this step properly could
cause an inlet for moisture into the system.
2. Set the palm rest onto the right side and tilt the palm rest up connect the USB Hub board to
system board cable (ribbon cable). Then connect the LCD to USB Hub board cable.