Filter
Top Products
Chapter 3
Advanced Configuration
11
Wireless-N Broadband Router with Storage Link
Standard Channel If Standard - 20 MHz Channel is the
Channel Width setting, then this setting will be available.
Select the appropriate channel for your wireless network.
If you are not sure which channel to select, then keep the
default, Auto.
If Wide - 40MHz Channel is the Channel Width setting,
then the Standard Channel will be a secondary channel
for Wireless-N (2.4 GHz).
If you selected a specific channel for the Wide Channel
setting, then the Standard Channel options will vary.
Select the appropriate channel for your wireless network.
SSID Broadcast When wireless clients survey the local
area for wireless networks to associate with, they will
detect the SSID broadcast by the Router. To broadcast the
Router’s SSID, keep the default, Enabled. If you do not want
to broadcast the Router’s SSID, then select Disabled.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
Wi-Fi Protected Setup
There are three methods available. Use the method that
applies to the client device you are configuring.
Wireless > Basic Wireless Settings (Wi-Fi Protected Setup)
Wi-Fi Protected Setup Configured
NOTE: Wi-Fi Protected Setup configures one
client device at a time. Repeat the instructions
for each client device that supports Wi-Fi
Protected Setup.
Method #1
Use this method if your client device has a Wi-Fi Protected
Setup button.
Click or press the1. Wi-Fi Protected Setup button on
the client device.
Click the 2. Wi-Fi Protected Setup button on this
screen.
After the client device has been configured, click 3.
OK. Then refer back to your client device or its
documentation for further instructions.
Wi-Fi Protected Setup > Congratulations
Method #2
Use this method if your client device has a Wi-Fi Protected
Setup PIN number.
Enter the PIN number in the1. field on this screen.
Click 2. Register.