Filter
Top Products
Chapter 4 Configuring Wireless 13
Configuration Considerations
The PortServer TS 4 W works ONLY with the radio provided. You can use
the wizard to configure your wireless device available on the Software and
Documentation CD. You will need an Ethernet cable and a network PC to
configure the wireless device server. After assigning the IP address,
access the device from your browser by entering the IP address in the URL
address bar.
Install Radio
Place your country sticker on the back of the radio.
Slide radio into slot on top of Wireless device server BEFORE connecting
any cables or power supply. Only the radio shipped in the box will function
with the unit.
Note: Be sure that the grooves on the side of the radio are fit into the notched edges
of the Wireless device server. Gently push radio into slot; fit should be snug.
— WARNING - If the power is connected when you plug the radio
into the device server, you will be required to reboot. It is not
recommended that the radio be removed while the power is
connected!
Using Ethernet
1. Connect serial cable, Ethernet cable, and power supply.
Chapter 4
Configuring Wireless