Filter
Top Products
9
Wall Control Installation
to complete the installation
and to blend the installation in
with your choice of decor.
Hard Wired Power Supplied
Installation
Before starting this installation,
it is helpful to initialize the Wall
Switch Remote Control with your
rebox (see Initialization section).
You should have the following
items ready and prepared:
Installed standard wall device •
box with a minimum depth of
2.5 inch (6.35 cm).
A 24V~ power source leading •
to the device box. Possible
sources could be a 24V~
doorbell circuit or a Class 2
24V~ transformer.
The 24V~ wire leads coming •
into the device box should have
between 4 and 6 inches (10-15
cm) of slack left inside the box
to allow for ease of installation
and/or servicing.
You may also leave the •
supplied AAA batteries in the
Controller. There is an internal
electronic bypass that will draw
on the hard wired power source
before the batteries.
Figure 8
Outer
Housing
Controller
Guides
Tracks
Figure 9
Controller
Flat head screws
(supplied)
Wall Box
Outer Housing
head screws (supplied) as
shown in Figure 9.
7. Attach your choice of Decora
style faceplate (not supplied)