Filter
Top Products
11
♦ Link Test Function State Indicates the whether the port link-test is enabled or
disabled. If enabled, the port will check for link pulses, and will only transmit if
there is a good link to another station.
♦ Administration State Indicates the port’s partition status, either enabled or
disabled.
♦ Port Speed State Indicates how the port speed is set: auto-negotiation, 10Mbps,
or 100Mbps.
♦ Generate Trap When Link State Change Indicates whether or not the port will
send a trap if it’s link status changes.
♦ Generate Trap When Speed State Change Indicates whether or not the port
will send a trap if it’s speed changes.
Reset
Doing a remote reset is equivalent to turning the hub off and on again. All parameters
are returned to the values stored in EEPROM.
Click RESET to reset the Hub.