Filter
Top Products
86
How can I use eDonkey behind my D-Link router?
Frequently Asked Questions (continued)
You must open ports on your router to allow incoming traffic while using eDonkey.
eDonkey uses three ports (4 if using CLI):
4661 (TCP) To connect with a server
4662 (TCP) To connect with other clients
4665 (UDP) To communicate with servers other than the one you are connected to.
4663 (TCP) *Used with the command line (CLI) client when it is configured to allow
remote connections. This is the case when using a Graphical Interface (such as the
Java Interface) with the client.
Step 1 Open your web browser and enter the IP Address of your router
(192.168.0.1). Enter username (admin) and your password (leave blank).
Step 2 Click on Advanced and then click Firewall.
Step 3 Create a new firewall rule:
Click Enabled.
Enter a name
(edonkey).
Click Allow.
Next to Source,
select WAN under
interface. In the first
box, enter an *. Leave
the second box
empty.
Next to Destination,
select LAN under
interface. Enter the IP
Address of the
computer you are
running eDonkey
from. Leave the
second box empty.
Under Protocol,
select *. In the port
range boxes, enter
4661 in the first box
and then 4665 in the
second box. Click
Always or set a schedule.
Step 4 Click Apply and then Continue.
.
edonkey
.
WAN
LAN
*
192.168.0.100
*
4661
4665