Filter
Top Products
DSL-504T DSL Router User’s Guide
24
Static IP Address for WAN
WAN Settings - Static IP
1. Click to select the Static IP Address radio button listed in the WAN Settings options list.
The menu will change to offer a different set of configuration options.
2. Under the ATM VC Setting heading, do not change the PVC (Pvc0) index for the initial
connection.
3. If you have not been instructed to change the ATM (PVC) settings at the bottom of the
menu, leave these at the default settings. If you have been given new settings to configure,
type in the values for VPI and VCI. If you are setting up multiple connections, the
procedure for this is described in a separate section below.
4. Set the Virtual Circuit setting to Enabled in the pull-down menu if it is not already
enabled.
5. Select the Connection Type from the pull-down menu under the Static IP heading. Your
ISP should provide this information to you. The available options are IPOA, 1483 Bridged
VC-Mux, 1483 Bridged LLC, and 1483 Routed VC-Mux. If have not been provided specific
information for the Connection Type setting, leave the default setting.
6. Change the IP Address, Subnet Mask, Gateway Address and (if available) Secondary
DNS Server IP address as instructed by your ISP. Your ISP should have provided these IP
settings to you.
7. When you are satisfied that all the WAN settings are configured correctly, click on the
Apply button.
8. The new settings must be saved and the Router must be restarted for the settings to go
into effect. To Save & Reboot the Router, click on the Tools directory tab and then click
the Save & Reboot menu button. In the Save and Reboot menu, click the Reboot button
under Force the DSL-504T to system restart. The Router will save the new settings and
restart. Upon restarting the Router will automatically establish the WAN connection.
When the Router is configured to
use Static IP Address assignment
for the WAN connection, you must
manually assign a global IP
Address, Subnet Mask and
Gateway IP Address used for the
WAN connection. Most users will
als
o to configure DNS server IP
settings in the DNS Settings
configuration menu (see below).
Follow the instruction below to
configure the Router to use Static
IP Address assignment for the
WAN connection.