Filter
Top Products
DE-220P Series Ethernet Adapter
/
User’s Guide
----------------------------------
Multiple Cards in a Non-PnP
System
In non-PnP
systems,
the procedure for configuring
multiple DE-220P Series cards is basically a se-
quence of separate single-adapter procedures:
make a preliminary installation of each card alone
in turn: make a
setup. exe run to configure that
card, then remove that card and go on to the next,.
CAUTION: The following procedure involves operation of the
computer without its chassis housing in place.
Caution is necessary in order to avoid contact
with exposed high-voltage parts.
Accidental
contact with exposed internal parts can cause
personal injury and can cause damage to the
computer equipment.
Make a preliminary installation of the first, DE-
220P Series card by completing
Steps
1 through 3
as set
out. in the ‘Single-Adapter Installation” sec-
tion above.
Restore power to the computer, and configure the
card by running the supplied setup program,
setup. exe. Make a note of
the
configuration
settings that, you select,
to
help you select, different
settings in configuring
the
remaining cards.
Shut. down
the
computer and unplug
its
power
cord. Remove
the
(configured) card, and install
the
next. DE-220P
Series
d into
any
open
ex-
pansion
slot.
2-10