Filter
Top Products
Master Hub Setup and Management 49
♦ Boot Server IP Address
. This variable is the IP address of the TFTP
server where the configuration file is located. This entry is used only if
the
S/W Update Control
is enabled and your boot protocol is TFTP
only; if you are using BOOTP&TFTP mode, or if
Send BOOTP Re-
quest on Power Up
is enabled, the address will be obtained from the
BOOTP server.
♦ Boot File Name
. The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the .CFG file on your hard disk. This entry is used
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if
Use BOOTP to get IP after start up
is en-
abled, the pathname will be obtained from the BOOTP server. For
more information about the DFE-2600 series master hub configuration
file, see
Appendix C,
Boot Configuration File.
DFE-2600 Stackable Hub - Software Update Menu
Software Update <Disable>
Software Update Mode <Network >
Boot Protocol <TFTP ONLY >
Boot Server IP Address [210.68.85.36 ]
Boot File Name [c:\dfe2600i.cfg ]
Last Boot Server IP Address: 210.68.85.35
HELP SAVE EXIT
SNMP Information
The System Configuration Menu screen shows a variety of information about
your hub, and allows you to set the System Name, System Location, and
System Contact. These settings can be retrieved from the hub using SNMP