Filter
Top Products
Dual-Speed Stackable Hubs User’s Guide
Master Hub Setup and Management70
(including TCP/IP parameters, SNMP parameters, the enabled/disabled set-
tings of ports, etc.) will be erased and restored to their factory default
settings.
1.
Choose
Factory Reset NVRAM to Default Value
from the main
menu. A confirmation message similar to that for the System Reset
will appear.
2.
Move the cursor to
Yes
to confirm the reset and press
<Enter>.
After a few seconds delay, the hub should restart, and all of its
parameters will revert to their default values.
Note: Doing a factory reset to the Primary Master al-
so resets the Backup Master variables except
for the the Backup Master IP address.