Filter
Top Products
22
Configuring the Switch
The DGS-1224T Web Smart Switch has a Web GUI interface for
smart switch configuration. The Switch can be configured through the
Web Browser. A network administrator can manage, control and
monitor the switch from the local LAN. This section indicates how to
configure the Switch to enable its smart functions including:
u
Port Setting (Speed/Disable, Duplex mode, Flow Control and
Port base QoS)
u
Virtual LAN Group setting (VLAN)
u
Port-based Trunking
u
Port-based Mirroring
u
System Setting
u
Device status and Statistic
Login
Before you configure this device, note that when the Web Smart
Switch is configured through an Ethernet connection, make sure the
manager PC must be set on same the
IP network
. For example, when
the default network address of the default IP address of the Web Smart
Switch is
192.168.0.1
, then the manager PC should be set at
192.168.0.x (where x is a number between 2 and 254), and the default
subnet mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter IP address
http://192.168.0.1
(the factory-default IP address
setting) to the address location.
Figure 13.