Filter
Top Products
DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
17
Connecting the DPS-200 to the RPS Port
The DPS-200 redundant power supply can be connected to the RPS port of the Switch using the DC power supply
cord, called the DPS-CB150-2PS. It is important to notice that the DPS-200 can supply power to one or two
DGS
-300
0 at the same time.
Figure 2-12 Connecting two Swtiches to the DPS-200
The following section explaines how to connect the DPS-200 to the Switch.
1. Disconnect the Switch from the main AC power source.
2. Insert the 14-pin end of the DPS-CB150-2PS into the DPS-200 and the 2-pin end into the receptacle of the
RPS port on the Switch.
3. Using a standard AC power cord, connect the DPS-200 to the main AC power source. A green LED on the
front panel of the DPS-200 will illuminate to indicate a successful connection.
4. Make sure that the ON/OFF toggle switch on the rear panel of the Switch is turned on.
5. Re-connect the Switch to the AC power source and power on the DPS-200.
No configuration is needed in the Switch software for this installation.
NOTE: See the DPS-200 Quick Installation Guide for more information.