Filter
Top Products
18
Using the Configuration Menu (continued)
Advanced > Mode (continued)
Enter the MAC address
to configure the Wireless Client and the Wireless Bridge modes
Wireless Client mode
Wireless Bridge mode
When using the DWL-2000AP in Wireless
Client mode, you will enter the MAC address
of the Remote AP.
Find the MAC address of the DWL-2000AP that is acting as a Remote Access
Point or a Remote Bridge, by going to Status > Device Info in the configuration
utility of the remote DWL-2000AP. There you will find the MAC address as
shown above.
When using the DWL-2000AP in Wireless
Bridge mode, you will enter the MAC address
of the Remote Bridge.
MAC Address - Media Access Control Address
A unique hardware address that identifies a device on a network. It is assigned
at the factory and cannot be changed. Usually you will find this address on a
sticker on the device or packaging.